Med Java

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Docker Firewall Configuration (firewalld) ======

===== Why are these commands needed? =====

The following commands are essential to allow Docker containers to communicate properly with the external network when using **firewalld** as the system firewall:

<code>
sudo firewall-cmd --add-masquerade --permanent
sudo firewall-cmd --reload
sudo systemctl restart docker
</code>

===== Detailed Explanation =====

=== 1. Masquerade (NAT) ===
**Command:** <code>sudo firewall-cmd --add-masquerade --permanent</code>

**Why it's needed:**
* Docker uses internal virtual networks for containers
* Containers have private IP addresses (typically in the 172.17.0.0/16 range)
* **Masquerade** (NAT - Network Address Translation) enables:
  - Containers to access the internet
  - Outbound traffic to use the host's IP address
  - Inbound connections to be routed to the correct containers

**Analogy:** Like a post office that receives mail for apartments in a building and delivers it to the correct recipients.

=== 2. Reload firewall ===
**Command:** <code>sudo firewall-cmd --reload</code>

**Why it's needed:**
* Applies configuration changes made with the ''--permanent'' option
* Firewall rules become immediately active
* Ensures settings persist after reboot

=== 3. Restart Docker ===
**Command:** <code>sudo systemctl restart docker</code>

**Why it's needed:**
* Docker needs to detect the new firewall rules
* Reloads network configuration
* Ensures new containers will benefit from updated settings

===== What happens without these settings? =====

* Containers **cannot access the internet**
* Services in containers **are not accessible from outside**
* Network connections fail
* Port forwarding doesn't work correctly

===== Practical Example =====

After running these commands, you can run:

<code>
docker run -p 80:80 nginx
</code>

And the nginx server will be accessible from your network at: http://host-ip-address

===== Verification =====

To verify that masquerade is enabled:

<code>
firewall-cmd --query-masquerade
</code>

Should return ''yes''.

===== Important Notes =====

* These settings are only needed if you use **firewalld**
* On systems with direct iptables, Docker manages rules automatically
* Settings are persistent due to the ''--permanent'' option

===== Additional Resources =====
* [[https://docs.docker.com/network/|Official Docker Networking Documentation]]
* [[https://firewalld.org/documentation/|firewalld Documentation]]

======